After the successful binder identification, the GeoDict Result Viewer opens for the result file (.gdr). Under the Results - Report tab, the percentage of voxels identified as binder is shown.

In the Results – Plots subtab the binder distribution is presented in form of binder percentage for each layer in z-direction of the structure.

Load the structure with identified binder, by clicking Load *.gdt under the Binder Visualization tab.

The same slices of the structure as shown in 2D in the Binder identification section, can be seen here, now with binder separated from the fibers.

In the 3D visualization, the distribution of binder between the fibers is visible for the whole domain.

Analogous to Identify Fiber (AI) you can load the confidence field of the binder identification result by selecting Load *.npz under the Binder Visualization tab. The confidence field is stored channel_1:Numpy Field, so it is recommended to only check and load this component.

In order to verify and comprehend the binder identification process it might be useful to simultaneously visualize the Structure and the Volume Field. For a better visibility choose Transp. Mode as Volume and edit the Transparencies Options for Material ID 01 (fibers and binder coupled) such that you can see it properly (e.g. 0.80 like in this example).

To identify voxels with a predicted confidence larger than 0.5, choose a threshold value of 0.5 and the Clip Mode >= on the Volume Field tab. The identified binder voxels are now displayed in green to red and the remaining solid voxels in (transparent) gray.

This can be compared, e.g., with the result for a threshold of 0.8, where less voxels are identified as binder (displayed in orange and red), see figure on the right.